Management > Password Access Control; Management > Snmp > Snmp Global Settings - D-Link DGS-1100-05 User Manual

4 Configuration
Click Refresh button to update the port PoE status information.
Note: This switch conforms to IEEE 802.3af and 802.3at standards. The IEEE
PoE standard requires a switch to shut off power to a port if the power draw is
less than 10mA within a 400ms time interval. To support some non-standard
devices that may take longer, you may enable this feature to extend the time
interval to 500ms. If the PD is still not powering on, please contact the vendor
of your device for support.
Management > Password Access Control
The Password Access Control page allows the user to configure the access password of the Switch.
The fields that can be configured for Password Access Control are described below:
Item
Old Password
New Password
Confirm Password
Click Apply to make the configurations take effect.
Management > SNMP > SNMP Global Settings
Simple Network Management Protocol (SNMP) is an OSI Layer 7 (Application Layer) protocol designed
specifically for managing and monitoring network devices. SNMP enables network management stations to
read and modify the settings of gateways, routers, switches, and other networks. Use SNMP to configure
system features for proper operation, monitor performance and detect potential problems in the Switch or
LAN.
This panel allows the user to configure the SNMP settings, used for managing and monitor devices on the
network.
The fields that can be configured are described below:
Note: For the PoE Port Settings table, if the
classification was shown as "Legacy PD", it will be
classified to non-AF PD or Legacy PD.
Figure 4.19 – Management > Password Access Control
Description
Enter the old password of the Switch.
Enter the new password of the Switch.
Enter the new password of the Switch again.
Table 4.6
Figure 4.20 – Management > SNMP > SNMP Global Settings
D-Link Smart Managed Switch User Manual
20