Table of Contents
Advertisement
ENGLISH
WATER HAS ENTERED THE
ERGORAPIDO CLEANER
It will be necessary to replace the motor at an authorized Electrolux
service center. Damage to
the motor caused by the penetration of water is not covered by the
warranty.
If you can't find accessories for your Electrolux vacuum cleaner,
please visit our website at www.electroluxappliances.com(USA),
www.electrolux.ca (Canada) or call
1 800-896-9756.
REMOVING BATTERIES
CAUTION: Only remove batteries if product is to be scrapped.
Improper handling of the batteries may be hazardous. Batteries must
be removed from the appliance before it is scrapped or recycled.
Never dispose used batteries with household waste. Batteries should
always be completely discharged before removal. Ergorapido must
be disconnected from the charging station when removing the
batteries.
1. Undo the screws. Carefully lift the hood.
2. Cut the connecting cables, remove the batteries, put tape over the
visible metal areas. Place batteries in suitable packaging.
To locate nearest recycling center please call
1 877-273-2925 or visit www.call2recycle.org
TROUBLESHOOTING
1. Turn off power.
The brushroll stops spinning
2. Remove any obstructing objects from the brushroll.
3. Allow 5 minutes for motor to cool before powering on.
• Vacuum is too hot. Clean filters, brush roll and hose. Insert the
If a red light is lit
adaptor into the outlet and connect it to the charging station.
• If red light is blinking the motor is overloaded, causing the vacuum
If red light is blinking
to turn off. Clear obstruction from brushroll and turn Ergorapido on.
The BRUSHROLLCLEAN™ TECHNOLOGY
feature isn't working
1. Ensure your Ergorapido is fully charged.
2. Ensure you are pressing firmly on the pedal
while the Ergorapido is on.
3. Check if there are large carpet fibers, heavy threads, or wires in
the brushroll – the BRUSHROLLCLEAN™ TECHNOLOGY feature
will not be able to remove these obstructions.
10
Advertisement
Table of Contents
