Fluid Sensor Function - High End Systems FQ-100 User Manual

Fluid Sensor Function

The Fluid Sensor detects low fluid levels on FQ-100 fog machine.
When the fluid tank is empty (run out of fog fluid), the LCD menu screen starts
to flash "Empty Fluid" to warn users and the fluid pump stops working
automatically to protect the pump from burn out.
After you refill the fluid tank, press the MANUAL button until the LCD screen
displays to "Ready to Fog" again.
CAUTION!
When using Atmospheres fog fluid, always make sure there is
sufficient liquid in the fog liquid tank. Operating this unit
without liquid will cause damage to the pump as well as over-
heating of the heater.
When the fluid sensor is on, the LCD screen shows "Ready to Fog S" (The "S"
means "Sensor On"). When it is off, the LCD screen shows "Ready to Fog"
(without the "S").
If you do not need the fluid sensor function, you can use the control panel to
switch it off. To switch off the fluid sensor:
1. Press the FUNCTION button on the control panel until LCD screen shows
"Fluid Sensor On".
2. Press the UP/DOWN button to turn off the fluid sensor. The screen
displays "Fluid Sensor Off"
3. Pressing the UP/DOWN button again will turn the fluid sensor back on.
FQ-100 Fog Generator User Manual
9