Setup; Mounting; Filling The Tank; Starting Up The Unit - High End Systems FQ-100 User Manual

FQ-100 Fog Generator User Manual

Setup

Mounting

This model can be operated at a floor level or sitting on any regular surface.
CAUTION!
Do not allow the unit to have more than a 35° angle of
inclination.

Filling the Tank

This product is warranted for use only with Atmospheres® fog fluid.
CAUTION!
When using Atmospheres fog fluid, always make sure there
is sufficient liquid in the fog liquid tank. Operating this unit
without liquid will cause damage to the pump as well as
over-heating of the heater.
If your FQ-100 Fog Machine fails to work properly,
discontinue use immediately. Drain all fog liquid from the
tank, pack the unit securely (preferably in the original
packing material), and return it to your FQ-100 dealer for
service.
Keep fog machine upright.
Turn off or unplug when not in use.
This machine is not water or splash-proof. If moisture,
water, or fog liquid gets inside the housing, immediately
unplug the unit and contact a service technician or your
FQ-100 dealer before using it again.
There are no user serviceable parts inside. Always refer
your FQ-100 dealer or other qualified personnel for
servicing.
To fill the tank:
1. Place fog machine on a flat surface and remove fog liquid tank cap.
2. Fill with Atmospheres fog liquid about 3/4 full and replace cap.

Starting up the Unit

Plug the power cord into a grounded electrical outlet. Turn the power switch to
"ON". Warm-up is complete when the display shows "Ready to Fog"
6