Icom IC-M506 Instruction Manual page 91

D Target list display
In the plotter display, push [DISP] to switch to the target list
display, which shows all AIS targets being detected by the
transponder.
The AIS target data is sorted by the distance from your ves-
sel, and the closest target is located on the top of the list.
Push [∫] or [√] to select an AIS target.
Push [INFO] to display the detail screen of the selected AIS tar-
get. (p. 83)
Push [DSC] to transmit DSC call to selected AIS target.
w
q THE NUMBER OF TARGETS
Shows the number of AIS targets which are being detected
by the transponder.
w TARGET INFORMATION
Shows the following AIS target information:
, if the name is programmed.
AIS Receiver (Depending on versions)
D Danger list display
In the target list display, push [DISP] to switch to the dan-
ger list display, which helps you to find any dangerous target
whose CPA is within 6 nm (nautical miles) and TCPA is within
60 minutes of your vessel.
Push [∫] or [√] to select an AIS target.
Push [INFO] to display the detail screen of the selected AIS tar-
get. (p. 83)
q
q THE NUMBER OF DANGEROUS TARGETS
Shows the number of AIS targets which are being detected
by the transponder.
w DANGER TARGET INFORMATION
Shows the following dangerous target information:
w
, if the name is programmed.
9
1
2
3
4
5
6
q 7
8
9
10
11
12
13
14
15
16
82