Page 2
Preface Thanks for your favor in our product. To derive optimum performance from the product, please read this manual and the supplied Safety Information Booklet carefully before use. This manual is applicable to the following model: PD70X/PD70XG (X may represent 2, 5, 6 or 8) Digital Portable Radio PD70X (X may represent 2, 5, 6 or 8) LT Digital Portable Radio...
FCC Regulations this manual may be copied, modified, translated, or distributed in any manner without the express written Hytera is the trademark or registered trademark of Federal Communication Commission (FCC) requires permission of us. Hytera Communications Co., Ltd. (the Company) in PRC...
Documentation Conventions Items in the Package Product Overview For your better understanding of this manual, please Please unpack carefully and check that all items listed This section introduces the mechanical structure and the read the following conventions first. below are received. If any item is missing or damaged, programmable key features of this radio.
Shortcut Key Description Shortcut Key Description ● Short press of the TK key is assigned with To a d j u s t t h e p o w e r l e v e l To enable or disable the the Emergency On feature, long press Adjust Power quickly.
90% charged To remove the belt clip, loosen the screws. The LED glows green. Fully charged Use only the charger and battery specified by Hytera. The LED flashes red rapidly. Charging failure Charger LED can indicate the charging process. See the table below.
Adjust Power Level Call With this feature, you may switch power levels quickly. Generally, we recommend you to adopt low power for To ensure optimal volume of the transmitted voice, keep battery saving. However, if you cannot communicate with the microphone approximately 2.5 to 5 centimeters away radios located at a distant place with low power, please from your mouth.
Functions and Operations Roam ▼ Note: You can transmit an all call only when the feature is enabled by your dealer. However, This feature allows the radio to communicate between you cannot call back an all call. sites in the same IP Multi-site Connect system. After Rent the feature enabled, the radio can communicate via any Calls on Analog Channels...
Covert Mode MIC AGC radio sounds background noise. Press the key again to disable the feature (a low-pitched tone sounds). When this feature is enabled, the radio will disable any T h i s f e a t u r e i s e n a b l e d b y y o u r d e a l e r v i a t h e ●...
radio will give an alert tone if it tilts to a certain gradient Call Hold Time: the duration the radio stays at in-call Scrambler /Encrypt ▼ (defined by the dealer) or stay motionless until the preset status after the end of the call. The Call Hold Time This Encrypt feature can encrypt your audio signals period (10s by default) expires.
Page 12
● Turn off the radio. Emergency Type In this mode, you can send alarm i n f o r m a t i o n b y p r e s s i n g t h e ● Once the emergency cycles expire, the radio will exit Different Emergency types will have different indications, programmed Emergency On key.
Page 13
Exiting the emergency alarm: 4. If the preset Voice Cycles expire, you can hold the Note: Your dealer may set the number of alarm PTT key to make the emergency call again (the LED The emergency alarm initiator exits the Emergency cycles and alarm duration (None, 5-Tone), glows red).
Troubleshooting Phenomena Analysis Solution The battery may be improperly installed. Remove the battery and attach it again. The battery may run out. Recharge or replace the battery. Power-on failure The battery may suffer from poor contact caused Clean the battery contacts. If the problem can not be solved, contact your dealer by dirtied or damaged battery contacts.
Ni-MH batteries) MCA06 ● Make sure the product is completely dry before use. Caution: Use the accessories specified by the Company only. If not, Hytera shall not be liable for any losses or damages arising out of use of unauthorized accessories.
Appendix 2. When the format consists of fixed codes only, you do not have to edit such fields or save such data. 3. Hold the PTT key or press the programmed One Signaling Introduction Touch Call key to send the 2-Tone signaling. The radio supports the following signaling.
Need help?
Do you have a question about the PD702 and is the answer not in the manual?
Questions and answers