Table of Contents
Advertisement
This operation is required following replacement of
certain elements of the suspension system.
1. Position the front end rear suspension arms :
tor ( 2 ).
the carpet.
a ) Undo front automatic control collar ( 5 ).
b ) Undo rear corrector attachment screws ( 3 ). Posi-
tion in the middle of the slot. and retighten.
c) Move the manual height control lever to normal
NOTE : The height control lever has three positions:
a - normal running
b intermediate
d ) If necessary. release any stress on the corrector
slide-valve, displacing sector ( 6 ), and undoing
control bush nut ( 4 ).
e) Position the suspension arms so that :
( 9 ) are in the mid-way position :
J l =J2+2mm
f ) Check that the front and rear corrector slide-valves
are in the neutral position.
2. Tighten the front automatic control collar :
At front: leave the corrector slide-valve ball-pinfree( d
Collar tightening torque : 1.4 to 1.5 m.daN
3. Fit :
Hide quick links:
Advertisement
Table of Contents
