Special Caution And Safety Notices; General Safety - Lenovo Storage V7000 Quick Installation Manual

DANGER
Main Protective Earth (Ground):
This symbol is marked on the frame of the rack.
The PROTECTIVE EARTHING CONDUCTORS should be terminated at that point. A recognized
or certified closed loop connector (ring terminal) should be used and secured to the frame with
a lock washer using a bolt or stud. The connector should be properly sized to be suitable for
the bolt or stud, the locking washer, the rating for the conducting wire used, and the considered
rating of the breaker. The intent is to ensure the frame is electrically bonded to the PROTECTIVE
EARTHING CONDUCTORS. The hole that the bolt or stud goes into where the terminal conductor
and the lock washer contact should be free of any non-conductive material to allow for metal to
metal contact. All PROTECTIVE EARTHING CONDUCTORS should terminate at this main protective
earthing terminal or at points marked with

Special caution and safety notices

This information describes special safety notices that apply to the Lenovo Storage V7000 system. These
notices are in addition to the standard safety notices supplied and address specific issues relevant to
the equipment provided.

General safety

When you service the Lenovo Storage V7000, follow general safety guidelines.
Use the following general rules to ensure safety to yourself and others.
• Observe good housekeeping in the area where the devices are kept during and after maintenance.
• Follow the guidelines when lifting any heavy object:
1. Ensure that you can stand safely without slipping.
2. Distribute the weight of the object equally between your feet.
3. Use a slow lifting force. Never move suddenly or twist when you attempt to lift.
4. Lift by standing or by pushing up with your leg muscles; this action removes the strain from the
muscles in your back. Do not attempt to lift any objects that weigh more than 18 kg (40 lb) or objects
that you think are too heavy for you.
• Do not perform any action that causes a hazard or makes the equipment unsafe.
• Before you start the device, ensure that service representatives and other personnel are not in a
hazardous position.
• Place removed covers and other parts in a safe place, away from all personnel, while you are servicing
the unit.
.