Table of Contents
Advertisement
1. Turn off everything (unless instructed otherwise).
2. Attach all cables to the devices.
3. Attach the signal cables to the connectors.
4. Attach the power cords to the outlets.
5. Turn on the devices.
– Sharp edges, corners and joints might be present in and around the system. Use care when
handling equipment to avoid cuts, scrapes and pinching.
Tools needed
A flat-blade screwdriver with a 7 mm (1/4 inch) head is the only tool needed for installation.
Reviewing your packing slip
After you open your shipment, you must verify the contents against the packing slip.
In each box, locate the packing slip. Verify that the items listed in the packing slip match what is in the box,
and that any optional items that you ordered are included in the list. Your shipment might contain extra
items, depending on the order.
Note: If you purchased your equipment through a reseller, some of the options might be preinstalled.
Contact your supplier for details.
Use the following checklist to check off the items in your order as you verify that they are included in your
shipment.
• Rack-mounting hardware kit:
– Two rails (right and left assembly)
– Two rail springs
– Two sets of rail-mount screws and alternative rail-mount pins (large and small) for various racks
• Two power cords for connection to rack-mounted power distribution units
• Drive bay blanking plates (installed in the enclosure)
• Publications package
Options applicable to control enclosures
Note: All options other than cables are preinstalled.
• Cache memory upgrade
• Four-port 8 Gbps Fibre Channel host interface adapter with two small form-factor pluggable (SFP)
transceivers installed
• Fibre Channel cables
• SAS cables
• Four-port 10 Gbps iSCSI / FCoE host interface adapter
• Compression accelerator
• Drives
• Power cords for connection to wall sockets
4
Lenovo Storage V7000 Quick Installation Guide
Advertisement
Table of Contents
