Virtual Circuit Settings - D-Link DSL-2740M User Manual

Section 3 - Configuration
Once you have configured your ISP's connection type, configure the Virtual Circuit Settings:
VPI: Virtual path identifier (VPI) is the virtual path between two
points in an Asynchronous Transfer Network (ATM) network. Its
valid value is between 0 and 255. Enter the correct VPI provided
by your ISP.
VCI: Virtual channel identifier (VCI) is the virtual channel between
two points in an ATM network. Its valid value is between 32 and
65535. Enter the correct VCI provided by your ISP.
Virtual Circuit: Enable or disable virtual circuit.
Select the Service Category your ISP uses. The options are CBR,
Service Category:
UBR, nrtVBR (non-realtime VBR), or rtVBR (realtime VBR)
PCR: Enter the Peak Cell Rate
If you selected nrtVBR or rtVBR configure the the following options:
SCR:
Enter the Sustainable Cell Rate.
MBS:
Enter the Maximum Burst Size.
If IPv6 is selected as the Connection IP Version, proceed to Dual Stack Lite on page 31.
Otherwise, click Save Settings or Connect to test your settings. Setup is complete.
D-Link DSL-2740M User Manual

Virtual Circuit Settings

30