Trap Assembly Instructions - Champion 40904 Owner's And Operator's Manual

Matchbird trap
Table of Contents

Advertisement

Available languages

Available languages

FIGURE 3
Tubes
Tubes
Connect
Connect
M6 x 90mm Hex
STEP 1.
TRAP BODY TO STAND (FIG-2)
Mount the Pivot Mount (C) to the left upright of the
trap stand using the 12mm Hex Nut (J-1). Orientate
the pivot mount (C) so that the serrated face of the
pivot mount faces to the right as shown. Tighten hex
nut securely. After mounting the Pivot Mount, mount
the trap to the pivot mount using the M12 x 35mm
Hex Bolt (J-2). Pivot the trap slightly above horizontal
and tighten the hex bolt securely. This setup will
provide a good starting point for target launch
direction. Attach Trap Body Handle (K) to Trap Body
using bolt (J-14) and washer (J-15) on Trap Body
Handle. Front of Trap Body Handle fits under top of
trap body into slot and is then bolted to Trap Body.
Attach Trigger (M) to tab on Trap Body (B) using 2
Bolts (J-13).
STEP 2.
TUBE SUPPORT ASSEMBLY (FIG-3)
Insert two M6 x 90mm Hex Bolts (J-7) through holes
in the short Rear Tube Support (J-6), through holes
in sides at rear of Trap Body (A) and through second
Rear Tube Support (J-6). Attach 6mm Flange Nuts (J-
8).
Attach Front Tube Supports (G) to front of trap

TRAP ASSEMBLY INSTRUCTIONS

Front Tube Support (G)
Front Tube Support (G)
M6 x 90mm Hex
Bolts
(J-7)
Tubes
Connect
Trap Body (B)
Rear Tube
Support (J-6)
Bolts
(J-7)
Tubes
12mm Hex
Connect
Nut
(J-1)
M12 x 35mm
Hex Bolt
(J-2)
following the same steps using the same size Hex
Bolts (J-7), and Flange Nuts (J-8).
MAKE SURE WARNINGS ON FRONT TUBE
SUPPORTS ARE UPRIGHT.
Tighten all four nuts on Tube Supports securely.
Slide three pieces of Arm Path Indicator Tubing (H)
over ends of Front Tube Supports (G) and Rear Tube
Supports (J-6). This ring indicates the approximate
path of the Throwing Arm (A).
7
Arm Path Indicator Tubing (H)
6mm
Trigger (M) &
Flange Nuts
6mm x 12mm Lg. Bolts (J-13)
(J-8)
Flange Nuts
Rear Tube
Support (J-6)
Trap Body Handle (K)
Pivot
Mount (C)
FIGURE 2
6mm
(J-8)
Tubes
Connect
6mm x 24mm
Hex Bolt &
M6 x 18mm
Washer
(J-14 & J-15)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

40907

Table of Contents