Stand Assembly Instructions - Champion 40904 Owner's And Operator's Manual

USE THE FOLLOWING INSTRUCTIONS TO ASSEMBLE THE TRAP STAND (FIG-1).
NOTE: YOU WILL NEED APPROPRIATE SIZE WRENCHES TO ASSEMBLE THE TRAP STAND
1. Attach the Front Frame Tube (C) to the Rear Frame Tube (D) using two (2) M10 x85mm Bolts (G-8), four
(4) 10mm Flat Washers (G-5), two (2) 10mm Lockwashers (G-6) and two (2) 10mm Hex Nuts (G-7).
2. Mount the Seat (A) to the Rear and Front Frame Assembly (C&D) using four (4) M6 x 25mm Lag Bolts
(G-2) and four (4) 6mm Flat Washers (G-1).
3. Mount the (2) Rear Legs (F) to the Rear and Front Frame Assembly (C&D) using two (2) M10 x 75mm
Bolts (G-4), two (2) 10mm Flat Washers (G-5), two (2) 10mm Lockwashers (G-6) and two (2) 10mm Hex
Nuts (G-7).
4. Mount the two (2) Front Legs (E) to the Trap Mount Frame (B) using two (2) M10 x 20mm Bolts (G-3),
two (2) 10mm Flat Washers (G-5) and two (2) 10mm Lockwashers (G-6) for each Leg.
5. Mount the Rear and Front Frame Assembly (C&D) to the Trap Mount Frame (B) using four (4) M10 x
75mm Bolts (G-4), eight (8) 10mm Flat Washers (G-5), four (4) 10mm Lockwashers (G-6) and four (4)
10mm Hex Nuts (G-7).
6. MAKE SURE ALL FASTENERS ARE SECURELY ATTACHED AND TIGHTENED.

STAND ASSEMBLY INSTRUCTIONS

4
FIGURE 1