Table of Contents
Advertisement
CHAPTER 9: PRECAUTIONS ON MOUNTING
(3) Components which are connected to the V
resistors, should be connected in the shortest line.
In particular, the V
Do not connect anything to the V
<Arrangement of Signal Lines>
In order to prevent generation of electromagnetic induction noise caused by mutual inductance, do
not arrange a large current signal line near the circuits that are sensitive to noise such as the oscilla-
tion unit.
When a signal line is parallel with a high-speed line in long distance or intersects a high-speed line,
noise may generated by mutual interference between the signals and it may cause a malfunction.
Do not arrange a high-speed signal line especially near circuits that are sensitive to noise such as the
oscillation unit.
<Precautions for Visible Radiation (when bare chip is mounted)>
Visible radiation causes semiconductor devices to change the electrical characteristics. It may cause
this IC to malfunction. When developing products which use this IC, consider the following precau-
tions to prevent malfunctions caused by visible radiations.
(1) Design the product and implement the IC on the board so that it is shielded from visible radiation
in actual use.
(2) The inspection process of the product needs an environment that shields the IC from visible
radiation.
(3) As well as the face of the IC, shield the back and side too.
56
Bypass capacitor connection example
V
DD
V
SS
, V
and V
voltages affect the display quality.
L1
L2
L3
, V
and V
L1
L2
Prohibited pattern
Large current signal line
High-speed signal line
, V
, V
and V
terminals, such as capacitors and
S1
L1
L2
L3
terminals when the LCD driver is not used.
L3
OSC4
OSC3
V
DD
EPSON
V
DD
V
SS
E0C6006 TECHNICAL MANUAL
Advertisement
Table of Contents
