JVC FS-SD58V Service Manual page 8

FS-SD58V/FS-SD78V/FS-SD98V
3. Remove the screw G attaching the heat sink board
on the back of the body. Disconnect the wire from
connector CN301 and pull the heat sink board fully
outward.
4. Raise the right and left door arms by turning the gear
a in the rear of the heat sink board.
5. After the CD mechanism base assembly is detached
from the door arms, pull the CD mechanism base
assembly toward the front and disconnect the wire
from connector CN804 on the left side of the door
arm board.
6. Pull out the CD mechanism base assembly toward
the front.
I
Door arm
CD mechanism base assembly
Door arm board (L)
CN804
1-8
CD mechanism base assembly
Door arm
Heat sink board
Gear a
Fig.12
Fig.14
CD mechanism base assembly
Main board
CN101
F
CN804
CD mechanism base assembly
Heat sink board
G
Fig.13
F
I
CN705
Fig.9
CD mechanism base assembly
Fig.10
CN301
Fig.11
Gear a