Page 1
Preface MOTOROLA’s Bluetooth Headset CHYN4590A is a cordless mobile solution built on Bluetooth wireless technology. Please proceed the instructions before using your Headset What is Bluetooth Technology? The Bluetooth wireless Technology eliminates constraint of cables by making connection to any portable and stationary device realized.
Decide on which ear you want to wear the headset (factory setup is for right-ear use). Pair the Headset with a device (mobile phone). Use appropriate MOTOROLA charger to charger the Headset The above stages are described in detail below.
Page 3
Putting On the Headset Put on the Headset with the ear clip behind your ear. Ensure the microphone is pointing toward your mouth.
Page 4
4. The phone commences searching for the Headset as soon as the Headset passkey “0000” is entered, and press YES.. 5. When the search is complete, the display shows a list of available devices, ex. “CHYN4590A”, then press YES. 6. The preset Headset name may be modified to your own personal name tag now. Press YES. When pairing has been completed, the indicator light on the Headset flashes green.
After battery fully charged, do not recommend charging again while indicator light flashes green. Which Charger Can I Use Please use MOTOROLA travel charger to the Headset. How to Charge the Battery . Connect the adaptor into the Headset as shown in the picture.
Page 6
is worn. Making and Receiving Calls Once the Headset is successfully paired with your phone, you can use the Headset to make and receive calls, provided that the Headset is on and operated within up to 10m/ 30ft. with no solid obstructions of the phone. The Headset can be used with voice dialing if your phone supports this feature.
Page 7
Press the Headset button “SW3” or the NO key to end the call. Answering Calls When the Headset rings, press the button “SW3” on the Headset to answer a call. Single click “SW3” on the Headset or the NO key to end the call. Press ”SW3”...
Additional information Troubleshooting This section lists some problems that you might encounter while using your Headset. The Headset Indicator Light Flashes Red This indicates that the Headset is running on low battery and has limited talk time and standby time left. Charge the Headset for approximately 1 to 1.5 hours.
Page 9
Product Care • Use of non-Motorola original accessories may result in performance deterioration, product damage, injury, or electronic shock, and warranty termination. • Do not attempt to disassemble your Headset, as it does not contain any components serviceable or repairable by consumers.
Page 10
A new battery, or one that has not been used for a long period of time, could have reduced capacity the first few times it is used. • Use only Motorola original accessories. Use of non-original Motorola accessories could be risky and the warranty is void should the product failure is caused by using non-Motorola original accessories.
Page 11
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. 15.21 Federal Communications Commission (FCC) Statement The users manual or instruction manual for an intentional or unintentional radiator shall caution the...
Page 12
user is encouraged to try to correct the interference by one or more of the following measures: ---Reorient or relocate the receiving antenna. ---Increase the separation between the equipment and receiver. ---Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.