Motorola MOTOPURE H12 Manual

Motorola MOTOPURE H12 Manual

Universal bluetooth headset
Hide thumbs Also See for MOTOPURE H12:


Universal Bluetooth
Headset H12


Table of Contents

Summary of Contents for Motorola MOTOPURE H12

  • Page 1 ® Universal Bluetooth Headset H12 MOTOMANUAL...
  • Page 2 Figure 1 Figure 2...
  • Page 3 Figure 3 Figure 4 Figure 5...
  • Page 4 Figure 6 Charging Contacts Figure 7 Charging Contacts...
  • Page 5 Figure 8 Indicator Light Power Switch...
  • Page 6 See- 47-CFR-Sec.-15.21. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including...
  • Page 7: Before You Begin

    English Before you begin See fi gure 1 on page 1. Take a moment before you get started to familiarize yourself with your new ® H12 Bluetooth Hands-free Headset. 1. Power switch 2. Call button 3. Indicator light 4. Microphone 5.
  • Page 8: Wearing Your Headset

    Wearing your headset See fi gure 3 on page 2. Your H12 headset is supplied with multiple ear buds. The ear bud is fi tted onto the end of your headset’s earpiece speaker, and placed onto your ear when using your headset. Your headset’s performance is greatly dependent upon achieving a good fi...
  • Page 9 • The charging case is designed for portability and protection when headset is not in use. Case can be placed in a pocket or bag and can easily fi t into many car cup holders. • The desktop charger displays your headset for easy access at home or the offi...
  • Page 10: Turning Headset On And Off

    See fi gure 8 on page 4. To turn your headset on, slide the Power switch on (towards Power symbol on headset). The indicator light fi rst fl ashes blue for several seconds, then: • fl ashes blue (if paired and connected to with another device •...
  • Page 11: Pairing Your Headset

    Your phone and headset are now paired and ready to make and receive calls. To confi rm they are successfully paired and operating properly, place the headset over your ear and make a call from your phone. You will hear ringing from the headset. After you have successfully paired your phone and headset, you do not need to repeat these steps each time you use the headset.
  • Page 12: Indicator Lights

    Using your headset: Making & receiving calls Your headset supports both hands-free and headset profi les. Accessing call functions depend upon which profi le your phone supports. See your phone’s user’s guide for more information. Note: Some features are phone/network dependent.
  • Page 13 Quick red fl ash Low battery Note: After 20 minutes on a call or of inactivity, the light stops fl ashing to conserve battery power, but the headset remains in standby mode. Note: you can disable the indicator light as follows: •...
  • Page 14: Audio Tones

    Ring tone Incoming call Single high tone Phone network not available High to low tone End call Single high tone when Volume at maximum or minimum pressing volume button Ascending tone Mute enabled Low tone repeated Mute reminder very 15 seconds...
  • Page 15: Troubleshooting

    Make sure that any devices previously paired with the headset are turned off. If the indicator light is not steadily lit in blue, turn off both the other device and headset, wait 10 seconds, then turn headset back on. Wait for the indicator light to become steadily lit in blue, indicating the headset is now in pairing mode.

Table of Contents