Table of Contents
Advertisement
ADAPT VOICE
Voice Command is speaker independent, which means that no training or
adaptation is required. Some users with heavy accents or unusual voice
characteristics may find difficulty in achieving high accuracy with speaker
independent Voice Command, so the Adapt Voice feature allows users to
dramatically improve the recognition accuracy after adapting their voices.
Users who get acceptable recognition accuracy will find no additional
benefit to performing the Adapt Voice adaptation.
1.
From standby mode, press the OK Key [OK] to unlock the keypad,
then press the OK Key [MENU], select
then swivel to the QWERTY keypad and press
Commands.
2.
Press the Right Soft Key [Settings],
3.
Select
1. Train Voice
Directional Key up or down, then press the OK Key [OK].
Train Voice: Requires that you make recordings of your voice to
customize the voice recognitions system. It will take a few minutes.
Reset Voice: Once you finish the adaptation process, you can
reset the adaptation to factory default.
appears after you finish the
4.
Wait for the beep, and then repeat the sentences using a normal
tone of voice.
5.
When you are finished with a full session, you will reach a screen
that reads
"Adaptation
SETTINGS &
2.
Tools,
3. Adapt
Voice.
or
2. Reset Voice
by pressing the
Reset Voice
option only
Train Voice
process.
Complete".
PROMPTS
Allows you to select the voice command system characteristics.
1.
From standby mode, press the OK Key [OK] to unlock the keypad,
then press the OK Key [MENU], select
then swivel to the QWERTY keypad and press
Commands.
2.
Press the Right Soft Key [Settings],
3.
Select
1. Mode
Key up or down, then press the OK Key [OK].
TOOLS,
Mode:
1. Voice
following:
- Prompts: For handset to prompt for required information.
- Readout+Alerts: For handset to prompt for required
information and readout the contents of the screen and phone
alerts.
- Readout: For handset to prompt for required information
and readout the contents of the screen.
-
Tones
guidance.
Audio playback:
speakerphone
Speakerphone
down.
4.
Press the OK Key [SET].
SETTINGS &
4.
Prompts.
or
2. Audio playback
by pressing the Directional
Select the voice command system mode from the
Only: For handset to provide beeps only for audio
Allows audio playback to play through the
or
earpiece.
Select
or
Earpiece
with the Directional Key up or
TOOLS,
2.
Tools,
1. Voice
Automatic,
65
Advertisement
Table of Contents
