Table of Contents
Advertisement
48
B – Answering device: 2 Operation
ADAD function, operation
(once you have set up and switched on the ADAD function):
1. The answering device records a message.
2. The telephone calls the telephone number specified by you.
After accepting the ADAD call:
3. The recorded ADAD message is played back
(e. g.: "There is a new message. Please enter your PIN.").
4. The answering device now waits 90 seconds for entry of the correct
PIN. The "square" (#) key must be pressed before and after the PIN
(Entry: # – PIN – #). If the PIN is not entered or is incorrectly entered
the connection is broken after 90 seconds. After 5 minutes another
attempt is made (a total of 3 attempts).
5. After recognising the correct PIN the answering device plays back all
messages not yet heard (as with remote polling).
Recording the
With handset on-hook:
ADAD
announcement
Lift handset -
Start recording:
End recording
Entering/
-
changing ADAD /
telephone num-
bers
(
delete a possibly existing telephone number)
input tel. number: maximum 20 digits -
Switching ADAD
-
operation on and
off
Switch on or off -
ADAD test call
You can set up ADAD operation via the remote control (see 4.4). You can
check the setup by means of a test call:
The test call must originate from the connection which has also been
programmed as the destination of the ADAD telephone number
(ADAD tel. number). After starting the test call via the remote control code,
you can replace the handset. The programmed ADAD telephone number is
now called automatically. The ADAD announcement is played back as part
of the check.
function key -
select recording:
Start recording:
-
-
-
store
-
-
or
store setting
Important
note
Switching
the VIP function
on and off
-
Changing
the VIP code
-
Important
note
Switching
rooms functions
on and off
B – Answering device: 2 Operation
2.10
VIP function
Using the VIP function, the caller can "avoid" the switched on answering
device of the SmartLine D750. The call is then signalled by the tone caller
(on delivery: VIP function is switched off; VIP code ="0000").
To be able to use remote control and VIP function, the PIN and VIP
codes must be different.
Whilst the announcement is running, a "VIP caller" must make the follo-
wing entries. To this he/she requires a telephone with dual tone multifre-
quency signalling (DTMF) or a code transmitter (as with the remote control):
Press "square" key (#) – enter VIP code – press (#) again.
-
-
or
Switch on or off -
store setting
-
-
-
Enter new VIP code: 4 digits -
2.11
Room functions
The room functions can be switched on via the remote control (see 4.4). On
delivery the function is switched off. The activation of the room functions is
indicated at the telephone by the display text
If a caller switches the "Room supervision" on, the microphone of the
telephone is activated. The caller can hear what is being said in the room.
The function is very useful for checking that everything is "OK" at home
when you are not there.
When the "Room announcement" function is activated the microphone
and the loudspeaker of the telephone is switched on. The caller can talk to
anyone in the room.
By switching off the room functions, you are protected from unnoticed
eavesdropping due to "room supervision". The room function cannot then
be activated by a caller.
-
-
or
-
switch off or on -
49
-
-
-
-
-
Enter PIN
store setting
.
-
store setting
Advertisement
Table of Contents
