Table of Contents
Advertisement
20
A – Telephone operation:
3.4
Brokering
You can set up a 2nd call during a telephone call so that you can talk
alternately with both of the other parties (= brokering). During brokering, the
party that you are not talking to at that moment is put "on hold". He/she
cannot hear the other conversation.
You are in the middle of a telephone call:
-
Dial telephone number -
the 2nd party:
can switch between the two connections.
End brokering:
You are reconnected with the party you previously put on hold
3.5
Conference
You can set up a 2nd call during a telephone call so that you can
subsequently talk with both parties at the same time. For this, the ISDN
function "three-party conference" must be available for your line.
You are in the middle of a telephone call:
-
Dial tel. number -
party:
end conference:
Note
If one of the parties you are talking to ends the call, you remain connected
with the other one.
3.6
Parking
You can "park" a call. The connection still remains.
There are two ways to resume the call:
1. You pull the plug of the telephone at the telephone connection socket in
order to plug it into another socket (of the same multi-device line). You
can then resume the call there.
2. You can also resume the call at another SmartLine D750 operating at the
same ISDN line.
3 Telephoning: During a call
When you are connected with
By repeatedly pressing the consultation key, you
press disconnect key
When you are connected with the 2nd
-
A – Telephone operation:
Parking a call
You are in the middle of a call (
You can input a code (maximum 2 digits) for the connection .
The input is, however, not necessary.
Confirm storage
You can resume the call connection within 3 minutes.
Resuming the call
– (
)
Only if parking was performed using a code number:
Enter code (maximum 2 digits) ,
Confirm storage
Notes
The parking period must not exceed 3 minutes.
Resumption of the call can also be performed without previously lifting the
handset. The unit then automatically switches hands-free operation on.
4.1
Call list
Certain calls with transfer of the telephone number can be automatically
stored in the call list:
1. Not accepted calls (also applies when the capacity of the
answering device has been reached).
2. Camp-on busy calls which were refused.
A maximum of 10 calls are stored along with telephone number and the
message sent. With more than 10 calls the oldest entry is replaced by the
next incoming call.
Viewing the call list / deleting an entry
If list entries are available,
Viewing the list
(
)
select input
read
: date, time, number of calls
Select display of a Message (if present), or called MSN
Confirm
Or:
Deleting an entry
4 Comfort functions
)
-
–
is displayed in idle condition:
- display of the last caller
-
-
Confirm erase
21
Advertisement
Table of Contents
