Maintenance - RD WORKS FP201R Owner's Manual

3.Setting heat
Under standby mode, press Heater button to start heater.
Or
4.Setting flame
Under standby, press the Flame button to watch the flame effect.

MAINTENANCE

1. Turn off the heater with the power switch.
2. Unplug the unit and let it cool completely.
3. The outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if
necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter
the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the
heater. This may cause damage or deterioration to the surface.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.
Under standby mode, press the Heater button on the control panel
or remote control, the heater will start (The heater indicator is
under the artificial charcoal set. When heat is on, the charcoal set
will be lit up and flicker automatically at a slow pace). Press the
Heater button again. Heat and heater indicator will be off while
fan will prolong working for 30 seconds to emit plenty of heat
inside.
Caution: When the flame is on, the heater indicator will
remain lit if you turn off the heat.
Under standby, press Flame button, the flame will be on at the
brightest setting.
automatically at a slow pace.
Or
intensity of the flame decreases. There are five brightness levels you
can cycle through including the OFF setting.
Caution: When the heat is on, the charcoal set will stay lit if you
turn off the flame.
The corresponding light is on when timer –power-on is
set.
The charcoal set will be lit up and flicker
Each time this button is pressed, the
8