Table of Contents
Advertisement
Settings 2 Menu
Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the
Settings 2 menu. Press the cursor ▲▼ button to move up and down in the Settings 2 menu.
I
TEM
Auto Source
Auto Power Off
Direct Power On
Lamp Mode
Reset All
Status
Advanced 1
Advanced 2
Note :
The lamp is automatically dimmed to 30% if the BLANK button is pressed or it is there is no input signal
for 30 seconds.
Press the cursor ◄► button to enter and enable or disable automatic source
detection.
Press the cursor ◄► button to enter and enable or disable automatic shutdown of
lamp when no signal.
The standby mode is started if there is no input signal and the selected time period
(minutes) has elapsed with no operation. This function is disabled if "0" is selected.
Press the cursor ◄► button to enter and enable or disable a function to power on the
projector only by connecting the AC power cable.
Press the cursor ◄► button to enter and select the lamp mode for higher brightness
or lower brightness to save lamp life.
(Enter) / ► to reset all settings to default values.
Press
Reset All will not reset the following settings.
・Language
・Network
・Lamp Hour
(Enter) / ► to enter the Status menu. See page
Press
Status.
(Enter) / ► to enter the Advanced 1 menu. See
Press
page 47.
(Enter) / ► to enter the Advanced 2 menu. See
Press
page
59.
D
ESCRIPTION
– 45 –
46
for more information on
Advanced 1 Feature
on
Advanced 2 Feature
on
Advertisement
Table of Contents
