Table of Contents
Advertisement
Reverse steps 1 to 6 to
7.
install the new lamp
module.
While installing, align the
lamp module and ensure it
is level to avoid damage.
Note:
The lamp module must sit
securely in place before
tightening the screws.
The lamp connector must
be connected properly and
place as drawing before
Lamp cover installation
back.
Note:
Lamp Connector must be installed flush with the connector base as shown in the image below.
A gap between the Lamp Connector and the connector base will cause damage to the projector.
The following images illustrate correct and incorrect Lamp Connector installations.
Close the lamp cover and tighten the screws.
8.
No Gap
Correct
– 63 –
Gap
Incorrect
Advertisement
Table of Contents
