Download Print this page

Bunn Liquid Autofill Kits Installation Instructions Manual page 9

For bunn ultra-1; bunn ultra-1

Advertisement

1. Fill bucket with 4 gallons of 120 Degree F water and sanitizing solution to equal 100 ppm of available chlo-
rine.
Note: some installations may require more sanitizer solution to fill the supply lines completely.
2. Select "auger on" and set the cooling mode to "off" for each hopper being sanitized.
3. Empty product from each hopper being sanitized.
4. Pour one gallon of warm water into each hopper to rinse the remaining product, and then drain hopper(s).
5. Disconnect concentrate line from the B-I-B and set so the sanitizer can flow freely through it. Place the con-
nector in the bottom of the sanitizer solution bucket.
6. Select "auger refill on" for each hopper being sanitized. Allow hoppers to fill until system reaches the fill
probe. If a refill fault occurs, press the Ultra button to clear and continue filling. Repeat this process until the
product line runs clear.
Note: You may need to drain the hopper again and allow filling until the product line runs clear, indicating sani-
tizer has completely filled the lines. If the delay refill system is activated, you may also need to turn the auger
off, then back to "auger refill on" to fill the hopper without the delay.
7. Once full, allow sanitizer to sit in the hopper(s) for 10 minutes.
8. Select "auger off" for each hopper being sanitized. Drain the sanitizer from the hopper(s).
9. Remove the B-I-B connector(s) from the sanitizer bucket and reconnect to the product B-I-B(s).
10. Refer to the Recommended Cleaning instructions of the ULTRA operating manual and follow the steps to
remove, clean and sanitize the hopper(s), lid(s) and other dispense parts.
11. Select "auger refill on" for each hopper being sanitized and allow to run until product starts flowing into the
hopper(s).
12. Select "auger off" for each hopper being sanitized, then drain hopper(s).
13. The dispenser is now ready to be turned on and filled for use.
Auto-fill Sanitizing Instructions
(With Internal Brixing System Installed)
9
37570.2 081811

Hide quick links:

Advertisement

loading