Bunn Liquid Autofill Kits Installation Instructions Manual page 4

INSTRUCTIONS (Continued)
22. Using supplied cable tie (C), attach the
new harness to the main harness to
keep away from the condenser fan.
24. Reinstall front and side panels.
27. Slide hopper fitting into place in the
slot on the hopper.
Plumbing & Water Pressure Requirements
• Supply water pressure requirement is
50 – 80 psi.
Syrup supply is to be 30 – 80 psi.
25. Install hoppers onto machine and
slide probes onto hoppers into slots
provided.
28. Install customer supplied pump system.
Turn on pump system and water supply.
Check all tubing connections for leaks.
(Continued)
4
23. Connect syrup supply lines from BIB
system. Connect water lines from
source. NOTE: Connection points for
these are marked on the rear of the
motor cover.
26. Route the tubes from the motor cover
together and connect to hopper fitting.
37570.2 081811