Bunn Liquid Autofill Kits Installation Instructions Manual page 3

INSTRUCTIONS (Continued)
For ULTRA-1 Models that are Auto-fill ready:
15. Locate unused white and red auto-fill
valve wire connections tied in a bundle
on the main wiring harness. Carefully
cut wire tie to free the bundle.
19. Remove the two lower motor bracket
screws and align new bracket in place.
Attach with new screws (K ) provided.
16. Connect white and red wires from the
new harness (R) to white and red wires
repectively on the main harness. Route
the new harness toward the back of the
machine.
17. Install level probe assembly into hole
and secure with nuts provided (G).
20. Install larger metal bracket as shown.
Route light connection wires above
plastic boss to keep from being pinched
under the new mounting bracket. Route
torque sensor wires away to keep from
being pinched under metal mounting
bracket Secure with 4 nuts (J ) provided.
(Continued)
3
18. Position wire and connector away from
metal bracket as shown. Attach using
nuts provided. Pink is the right probe
and Tan is the left probe. Reinstall mo-
tors using original screws.
21. Connect harness to each new motor
cover assembly with Auto Fill, then
mount motor cover to machine with
new screws (N ) provided.
Hint: Align the motor cover in at the
top, then snap the bottom in place.
37570.2 081811