Priority Mapping Table And Priority Marking Configuration Example - HPE FlexNetwork 5510 HI Series Acl And Qos Configuration Manual

Figure 6 Network diagram
Switch A
Switch B
Configuration procedure
# Assign port priority to GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. Make sure the priority of
GigabitEthernet 1/0/1 is higher than that of GigabitEthernet 1/0/2, and no trusted packet priority type
is configured on GigabitEthernet 1/0/1 or GigabitEthernet 1/0/2.
<SwitchC> system-view
[SwitchC] interface GigabitEthernet 1/0/1
[SwitchC-GigabitEthernet1/0/1] qos priority 3
[SwitchC-GigabitEthernet1/0/1] quit
[SwitchC] interface GigabitEthernet 1/0/2
[SwitchC-GigabitEthernet1/0/2] qos priority 1
[SwitchC-GigabitEthernet1/0/2] quit
Priority mapping table and priority marking configuration
example
Network requirements
As shown in
•
The Marketing department connects to GigabitEthernet 1/0/1 of the switch, which sets the
802.1p priority of traffic from the Marketing department to 3.
•
The R&D department connects to GigabitEthernet 1/0/2 of the switch, which sets the 802.1p
priority of traffic from the R&D department to 4.
•
The Management department connects to GigabitEthernet 1/0/3 of the switch, which sets the
802.1p priority of traffic from the Management department to 5.
Configure port priority, 802.1p-to-local mapping table, and priority marking to implement the plan as
described in
Table 6 Configuration plan
Traffic
destination
Public servers
Internet
GE1/0/3
Switch C
Figure 7:
Table 6.
Traffic priority order
R&D department
Management
department > Marketing
Server
Queuing plan
Traffic source
R&D department
>
Management
department
29
Output Queue
queue priority
6 High
4 Medium