Table of Contents
Advertisement
Select Ring
To select a personalized
ring
Self-Test
To test the lights and
ringer of your voice
terminal
Press [
1
Select Ring
Green light goes on
2
Press [
]
#
Green light winks; current ring pattern plays and
repeats every 4 seconds
3
Adjust ringer volume with volume control switch on
left side of voice terminal, if desired
4
Repeat Step 2 to cycle through all 8 ring patterns
Press [
5
Select Ring
ring pattern
Your new ring is set; green light goes off
Note: If you receive a call go off-hook, or lose
power during selection, process is interrupted and
you must start again. If you lose power after you
have selected your personalized ring, you will have
to select your ring pattern again.
1
Press [
Select Ring
Green light goes on steadily
Press and hold [
2
The following occurs in sequence:
Ringer sounds; Message and Select Ring lights
and two columns of lights directly above dial pad
go on steadily for one second and then go off.
First column of lights to right of dial pad goes on
steadily for one second and then goes off
Second column of lights to far right of dial pad
goes on steadily and then goes off
3
Release [
Drop
Ringer and lights return to pretest state
Note: If ringer or lights do not respond during
test, notify your System Manager.
] (while on-hook)
] again when you hear the desired
] (while off-hook)
]
Drop
] to end test
18
Advertisement
Table of Contents
