Installation Checklist - Rheem RGPE series Installation Instructions Manual

Before beginning any troubleshooting procedure, complete the following installation checklist. A furnace malfunction is some-
times caused by an improper installation. By completing this checklist, the problem may be found and corrected. Make copies
of the checklist and complete one for every Low Profile Furnace service call for your records.

INSTALLATION CHECKLIST

(Refer to this manual for specifics.)
GAS SUPPLY
Adequate pipe size
No gas leaks
Proper supply and manifold gas pressure (check with an accurate U-tube manometer with the furnace and all other
gas appliances operating.)
ELECTRICAL
Correct thermostat and subbase
Correct thermostat mode and setting
Correct line supply voltage
Correct power supply polarity is required with electronic ignition
Correct furnace ground to electrical panel
DC microamp (∝A) flame signal (hot surface ignition units)
Correct control voltage
Measure and set heat anticipator amperage
Air conditioning low voltage wires connected to terminals "Y" "C" - not with wire nuts
VENTING
Correct vent pipe diameter and length (according to CSA tables)
Correct venting material (according to CSA tables)
Correct lining for masonry chimneys
Adequate clearance from combustibles
Proper negative pressure reading in the vent
Vent pipe secured to induced draft blower housing
COMBUSTION AIR
Proper source of combustion air
Correct combustion air opening size
FURNACE INSTALLATION
Adequate clearance from combustibles
Adequate clearance for service
Proper air temperature rise (See furnace rating plate)
External static pressure
Correct filter(s)
Correct cooling coil or accessories (if equipped)
Adequate supply and return air ducting
Air ducts sealed to prevent leakage
Thermostat model
Optional attic combustion air pull
Non-attic combustion air pull
inches w.c.
Return Air Duct Size
Subbase model
Vent connection size
Supply Air Duct Size
5