Advertisement
5.
Technichal Specifications
Technical Specifications
Weight: About 130g
Dimensions: 132.8x66.3x9.7mm
Band: GSM900MHz/DCS1800MHz/GSM850MHz/PCS1900MHz
WCDMA850MHz/WCDMA1900MHz
Battery Type: Li-ion
Talk Time: about 4-6h
Standby Time: about 400-600h
Battery Time (No prior or separate notice is required for capacity changes)
Note: Actual operating conditions depend on the local network environment, SIM, and user
behavior. Warning: Any consequence caused by misuse, abuse, or not following any and all
of the above-written suggestions and instructions shall not hold the producer in any way
responsible to any degree. Announcement: The manufacturer reserves the right to change or
upgrade specifications or software versions without prior or separate notice. Trademarks
mentioned or us ed in this material belong to their respective owners.
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions accepted by the FCC with the
phone transmitting at its highest certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level, the actual SAR level of the phone
while operating can be well below the maximum value, in general, the closer you are to a
wireless base station antenna, the lower the power output.Before a new model phone is a
available for sale to the public, it must be tested and certified to the FCC that it does not
exceed the exposure limit established by the FCC, Tests for each phone are performed in
positions and locations (e.g. at the ear and worn on the body)as required by the FCC.For
body worn operation, this model phone has been tested and meets the FCC RF exposure
20
22
6.
FCC cautions
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the inte rference by one or more of the following measures:
guidelines when used with an accessory designated for this product or when used wi th an
accessory that Contains no metal and that positions the handset a minimum of 1.0 cm from
the body. Non-compliance with the above restrictions may result in violation of RF exposure
guidelines.
interference to radio or
21
23
Advertisement
