Toshiba Strata DK User Manual page 39

Dialing Modifiers can be used for a variety of applications, including tone dialing, dial
pulse dialing, and pause and flash inserting. DIUs support the Dialing Modifiers listed
in Table 9 on Page
S-Registers: RPCIs and DIUs can be configured for specific applications with S-
Registers, which can only be changed or checked during the Command Mode. When
power is first applied to it and whenever its modular line cord is temporarily
disconnected and then reconnected, the RPCI and DIU initializes the S-Registers to
the default values and enters the Command Mode. DIUs support the S-Registers listed
in Table 7 on Page
procedure:
To check the value of an S-Register
Type ATSX? and
press Enter (X is
the S-Register you
want to check).
To change the value of an S-Register
Type ATSX=Y and
press Enter (X is
the S-Register you
want to change and Y
is its value).
Notes
A PC must be running communications software or a desk organizer dialing
program (be on-line) to issue AT commands. AT commands cannot be
inputted from a data telephone's dial pad, a PC DOS prompt, word processor,
database, or spread sheet-type programs.
AT commands are executed by the DIUs only after the carriage return key is
pressed. The carriage return is referred to as Enter in this guide. On some
keyboards, though, this key may have a different designation, such as
RETURN, <CR>, ENTER, etc.
All AT commands must be typed as capital letters.
Strata DK PC/Data Interface 5/00
36.
35. To check or change an S-Register, refer to the following
The value along with the "OK" Result Code is
displayed.
The S-Register value is now changed, and the screen
displays "OK". (If the entry is invalid, "ERROR" is
displayed in most cases.)
Mode Definitions
Data Communications Mode
31