General Operating Precautions - RCF HDL 12-AS Owner's Manual

Active line array module

Table of Contents

(wall, ceiling, structure, etc.), and the components used for attachment (screw anchors, screws, brackets not supplied by RCF

etc.), which must guarantee the security of the system / installation over time, also considering, for example, the mechanical

vibrations normally generated by transducers.

To prevent the risk of falling equipment, do not stack multiple units of this product unless this possibility is specified in the user

manual.

8. RCF S.p.A. strongly recommends this product is only installed by professional qualified installers (or specialised firms) who

can ensure correct installation and certify it according to the regulations in force.

The entire audio system must comply with the current standards and regulations regarding electrical systems.

9. Supports and trolleys.

The equipment should be only used on trolleys or supports, where necessary, that are recommended by the manufacturer. The

equipment / support / trolley assembly must be moved with extreme caution. Sudden stops, excessive pushing force and uneven

floors may cause the assembly to overturn.

10. There are numerous mechanical and electrical factors to be considered when installing a professional audio system (in

addition to those which are strictly acoustic, such as sound pressure, angles of coverage, frequency response, etc.).

11. Hearing loss.

Exposure to high sound levels can cause permanent hearing loss. The acoustic pressure level that leads to hearing loss is

different from person to person and depends on the duration of exposure. To prevent potentially dangerous exposure to high

levels of acoustic pressure, anyone who is exposed to these levels should use adequate protection devices. When a transducer

capable of producing high sound levels is being used, it is therefore necessary to wear ear plugs or protective earphones. See

the manual technical specifications to know the maximum sound pressure level.

To prevent the occurrence of noise on line signal cables, use screened cables only and avoid putting them close to:

- Equipment that produces high-intensity electromagnetic fields.

- Power cables

- Loudspeaker lines.

OPERATING PRECAUTIONS

- Place this product far from any heat sources and always ensure an adequate air circulation around it.

- Do not overload this product for a long time.

- Never force the control elements (keys, knobs, etc.).

- Do not use solvents, alcohol, benzene or other volatile substances for cleaning the external parts of this product.