Digital Audio Output - Haier HL42B-B Service Manual

1. Turn on the DVD player, insert a DVD.
2. Use the INPUT button on the remote control to select YPbPr mode.
3. Press Play button on external equipment for program play.
■ Component Input ports
To get better picture quality, connect a DVD player to the
Component ports on the TV
Video output ports on DVD player
DTV connection
This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However,
if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents
(480p,720p,1080i).
Y Pr Pb
DVI Audio IN
Audio In
Digital Set-top Box

Digital Audio Output

Send the TV`s audio to external audio equipment (stereo system) via
the Digital Audio Output (Optical) port.
How to connect
1. Connect one end of an optical cable to the TV Digital Audio
(Optical) Output port.
2. Connect the other end of the optical cable to the digital audio (optical)
input on the audio equipment.
See the external audio equipment instruction manual for operation.
Note: When connecting with external audio equipments, such as
4. Refer to the DVD player's manual for operating instructions.
Component input ports as shown below.
Y Pb
Y Pb
Y B-Y
Y Cb
Y P
How to connect
Use the TV`s (Y, PB, PR) , VGA or HDMI jack for video
connections, depending on your set-top box connector.
L R
Headphone
YPbPr
HDMI Optical
Audio In out
Then, make the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner`s
manual for the digital set-top box.)
2. Use INPUT on the remote control to select YPbPr, VGA,
or HDMI source.
17
Pr
Pr
R-Y
Cr
P
Β R
Signal YPbPr HDMI/DM
480i Yes Yes
480p Yes Yes
720p Yes Yes
1080i Yes Yes
L R
YPbPr Headphone
HDMI
Optical
out
Audio In