Table of Contents
Advertisement
3 Enter [9][8][0] in turn to enter Code Display Mode . LED is off.
4 Press and release [1] once, LED will flash. The times LED flashes is the first digit
of code number.(no flash = 0)
5 Press and release [2] once, LED will flash. The times LED flashes is the second
digit of code number. (no flash = 0)
6 Press and release [3] once, LED will flash. The times LED flashes is the third digit
of code number. (no flash = 0)
7 Code Display process is end and exit the mode automatically.
8 Under Code Display Mode, the remote controller will be no reaction to other buttons
pressed, and will automatically exit the mode if no any key is pressed within 10 seconds.
6. DISASSEMBLY INSTRUCTIONS
1. Remove the Pedestal
① Lay down the unit so that rear
cover faces upward
② Remove the four screw from the rear
cover indicated with
③ Then remove the pedestal
④
2. Remove the Back Cover
① Remove the twelve screws indicated
on figure above by
○
② Then remove the back cover from the
○
Remove the plank
3.
(The location of the plank as follows)
Remove the plank indicated on the
figure above
4. Remove the Terminal Bracket
① Remove thefive screws indicated on the
figure above by
② Then put the terminal bracket to the side
24
○
Advertisement
Table of Contents
