Connecting A Digital Audio Output - Haier L32F6 Service Manual

Service Manual
Model No.:
L32/42F6
audio outputs to the YPbPr Audio IN jacks on the TV,
as shown in the figure.
-
Note
If your DVD player does not have component video
output, use S-Video.
How to use
A
Turn on the DVD player, insert a DVD disc.
B
Use INPUT button on the remote control to select
component mode.
C
Press PLAY button on external equipment for
program play.
D
Refer to the DVD player's manual for operating
instructions.
Component Input ports
To get better picture quality, connect a DVD player to
the component input ports as shown below.
Component ports on the TV
-
Y Pb Pr
Video output ports on DVD
player
Connecting a DTV (digital TV)
This TV can receive Digital Over-the-air/Cable signals
without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other
digital external device, refer to the figure as shown below.
This TV supports HDCP (High-bandwidth Digital
Contents Protection) protocol for Digital Contents
(480p,720p,1080i).
How to connect
Use the TV's COMPONENT, VGA or HDMI jack for
video connections, depending on your set-top box
connector. Then, make the corresponding audio
connections.
How to use
A
Turn on the digital set-top box. (Refer to the owner's
manual for the digital set-top box.)
B
Use INPUT on the remote control to select
COMPONENT, VGA or HDMI source.
Signal COMPONENT
480i
480p
720p
1080i
1080p

Connecting a digital audio output

Send the TV's audio to external audio equipment (stereo
system) via the Digital Audio Output (Optical) port.
How to connect
A
Connect one end of an optical cable to the TV Digital
Audio (Optical) Output port.
B
Connect the other end of the optical cable to the
digital audio (optical) input on the audio equipment.
Y Pb Pr
Y B-Y R-Y
Y Cb Cr
Y P P
B R
HDMI
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
29