Connecting A Digital Audio Output - Haier LE32A300 User Manual

as shown in the figure.
How to use
Turn on the DVD player, insert a DVD disc.
Use INPUT button on the remote control to select
component mode.
Press PLAY button on external equipment for
program play.
Refer to the DVD player's manual for operating
instructions.
■
Component Input ports
To get better picture quality, connect a DVD player to
the component input ports as shown below.
Component ports on the TV
Video output ports on DVD
player
Y Pb Pr
Y Pb Pr
Y B-Y R-Y
Y Cb Cr
Y P P
B R
Connecting a DTV (digital TV)
This TV can receive Digital Over-the-air/Cable signals
without an external digital set-top box. However, if you do
receive Digital signals from a digital set-top box or other
digital external device, refer to the figure as shown below.
This TV supports HDCP (High-bandwidth Digital
Contents Protection) protocol for Digital Contents
(480p,720p,1080i).
How to connect
• Use the TV's COMPONENT, HDMI jack for video
connections, depending on your set-top box
connector. Then, make the corresponding audio
connections.
How to use
Turn on the digital set-top box. (Refer to the owner's
manual for the digital set-top box.)
Use INPUT on the remote control to select
COMPONENT, HDMI source.
Signal COMPONENT
480i
480p
720p
1080i
1080p

Connecting a digital audio output

Send the TV's audio to external audio equipment (stereo
system) via the Digital Audio Output (Optical) port.
How to connect
Connect one end of an optical cable to the TV Digital
Audio (Optical) Output port.
Connect the other end of the optical cable to the
digital audio (optical) input on the audio equipment.
See the external audio equipment instruction
manual for operation.
TV LED-TFT Owner's Manual
Installation
HDMI
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
EN-9