Fm Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips MCB240 User Manual

FM Radio Reception

Tuning to radio stations

1
Press SOURCE on the front panel of the
system or TUNER on the remote to select
TUNER.
2
Press and hold TUNE 1 / 2 (or
the remote).
➜
The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
3
Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press TUNE 1 / 2
(or / on the remote) briefly and
S T
repeatedly until you have found optimal
reception.

Programming radio stations

You can store up to a total of 30 FM radio
stations in the memory.

Automatic programming

Automatic programming will start with from
preset 1 and stop a the last programmed station.
All the former programmed radio stations will
be overridden.
1
Press PRESET3 / 4 (or ALBUM/PRESET 3
/ 4 on the remote) to select the preset number
where programming should start.
22
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROGRAM for more than 2 seconds to
activate programming.
➜
stations are programmed in order of waveband
reception strength: RDS followed by FM. The
last preset automatically stored will then be
played.

Manual programming

1
Tune to your desired station (see "Tuning to
radio stations").
2
Press PROGRAM to activate programming.
3
Press PRESET 3 / 4 (or ALBUM/PRESET
3 / 4 on the remote) to allocate a number
from 1 to 30 to this station.
4
Press PROGRAM again to confirm the setting.
➜
preset station are shown.
/ on
S T
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.

Tuning to preset radio stations

● Press PRESET 3 / 4 (or ALBUM/PRESET
3 / 4 on the remote) until the desired preset
station is displayed.

RDS

Radio Data System is a service that allows
FM stations to show additional information. If
you are receiving a RDS station,
station name are displayed.
When automatic programming is used, RDS
stations will be programmed first.
AUTO PROGRAM is displayed and available
The preset number and the frequency of the
and the