FM Radio Reception
Tuning to radio stations
1
Press SOURCE on the top of the system or
FM on the remote to select FM.
2
Press and hold the control knob on the front
panel of the system to the left or right
(corresponding to
remote.
➜
The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
3
Repeat step 2 if necessary until you find the
desired station.
18
5 /6
/
) or
on the
S
T
●
To tune to a weak station, press the control
knob on the front panel of the system to the left
or right (corresponding to
6
on the remote briefly and repeatedly until
you have found optimal reception.
Programming radio stations
You can store up to a total of 20 FM radio
stations in the memory.
Automatic programming
Automatic programming will start from preset 1
and stop at the last programmed station. All the
former programmed radio stations will be
overridden.
1
Press PRESET -/+ on the top of the system or
¡ / ™ on the remote to select the preset
number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press and hold the control knob on the front
panel upward (corresponding to PROGRAM)
or PROG on the remote for more than 2
seconds to activate programming.
➜
AUTO is displayed and available stations are
programmed in order of waveband reception
strength: RDS followed by FM. The last preset
automatically stored will then be played.
Manual programming
1
Tune to your desired station (see "Tuning to
radio stations").
2
Press the control knob on the front panel
upward (corresponding to PROGRAM) or
PROG on the remote to activate programming.
3
Press PRESET -/+ on the top of the system or
¡ / ™ on the remote to allocate a number
from 1 to 20 to this station.
4
Press the control knob on the front panel
upward (corresponding to PROGRAM) or
PROG on the remote again to confirm the
setting.
➜
The preset number and the frequency of the
preset station are shown.
5 /
/
) or
S
T