Table 5. System Trap Configuration Options; Table 6. I/O Port Trap Output Options - Canoga Perkins 3240S User Manual

4. Press <Space> to cycle to Enabled or Disabled and press <Enter>.
5. To return to the Main Menu, press <Esc>.

Table 5. System Trap Configuration Options

Type of Trap
2) Composite Sync Loss
3) Link Switch
4) Fault Relay State
5) System Loopback
6) Configuration Error
7) Card Insert/Remove
8) Backup Link OK/Bad
9) Cold Start/Authentication
10) Power Supply/Malfunction

Table 6. I/O Port Trap Output Options

Type of Trap
1) Per Port Loss of Sync or Alarm Indication Signal (AIS) occurs; also functions as master
enable/disable traps for each port
2) Port Loopback Port loopback is enabled or disabled
3) Port A Trap occurs on the selected I/O port
EdgeAccess
When enabled, sends a Trap if. . .
Received optical signal fails
The link switches between primary and secondary (backup)
A fault (alarm) occurs
System loopback is enabled or disabled
The same physical slots in two units hold mismatched types of I/O
cards or the time slot jumpers are mismatched; see page 2-1
An I/O card is inserted or removed
The backup link changes between good and failed
The 3240S is reset by a power-up or SNMP reset or an unauthorized
host attempts SNMP access with an incorrect community string
One of dual power supplies fails
When enabled, sends a trap if. . .
3240S Fiber-Optic Multiplexer
3-9/(3-10 Blank)