3
To reset:
Configuration mode is opened, RESET is lit.
Select the desired option with
with
:
· no: Instrument is not reset.
· Yes: Instrument is reset. The instrument is reset to
the factory settings.
- The instrument returns to measurement view.
6.
Measuring
This chapter describes the steps that are required to
perform measurements with the product.
Setting the material characteristic curve:
1
Switch between the display of wood moisture (F) and
building moisture (M):
2
Select the desired option with
with
:
Display
Category
F 1
Softwood lumber
F 2
Hardwood lumber
F 3
Chipboard
M 1
Cement screed
M 2
Anhydrite screed
M 3
Concrete
M 4
Solid brick
M 5
High-insulating brick
M 6
Limestone
M7
Gas concrete
CAL
Testing characteristic
/
and confirm
or press
.
or
and confirm
Example
Spruce, larch, cherry, pine, poplar, meranti
Beech, oak, maple, ash, Douglas-fir,
walnut, birch
Not for on-site measurements!
6. Measuring 25