ATC -2000WF Quick Start Manual page 9

set wlan ssid <string>
sets the wlan ssid to associate with. 1-32 chars.
NOTE: If the passphrase or ssid contain the SPACE
( ' ')characters, these can be entered using substitution
via the "$"character.
For example, if the ssid of the AP is "yellow brick road"
You would enter "yellow$brick$road"
Using the 'get w" command will properly display the
value:SSID=yellow brick road.
set wlan window <value>
sets the IP maximum buffer window size. Default is
1460 bytes.
4.0 GET Commands
These commands begin with "get". They display the
current values.
get adhoc display all adhoc settings.
get broadcast will display the broadcast UPD
address, port and interval
get everything displays all configuration settings,
useful for debug.
get com display comm. settings.
get dns display DNS settings.
get ftp display FTP settings.
get ip display IP address and port number settings.
get mac display the device MAC address.
get optional display the optional settings like device ID
get sys display system settings, sleep, wake timers,
etc.
get time display the time server UDP address and
port number.
get wlan display the ssid, chan, and other wlan
settings.
get uart display the UART settings.
Ver return the software release version
5.0 STATUS Commands
These commands begin with "show", and they return
the current values of variables in the system. In some
cases, for example IP addresses, the current values
are received from the network, and may not match the
stored values.
show net Displays current network status,
association,authentication, etc.
show rssi Displays current last received signal
strength.
show stats Displays current statistics, packet rx/tx
counters, etc.
show time Displays number of seconds since last
power up or reboot
6.0 ACTION Commands
$$$ enter command mode Characters are PASSED
until this exact sequence is seen. If any bytes are seen
before these chars, or after these chars, in a 250ms
window, command mode will not be entered and these
bytes will be passed on to other side.
close disconnect a TCP connection.
exit exit command mode. Exit command mode.
"EXIT" will be displayed.
factory RESET
Loads factory defaults into the RAM configuration.
Note that the RESET must be capitalized. After this
command the new settings must be save to the config
file using the save command and the module rebooted
for them to take effect.
join <ssid>
joins the network <ssid>. If network is security enabled
you must set the pass phrase with the set wlan phrase
command prior to issuing the join command
join # <num>
join a network from the scan list. <num> is the entry
number in the scan list that is returned from the scan
command. If network is security enabled you must set
the pass phrase with the set wlan phrase command
prior to issuing the join command
leave disconnects from currently associated Access
Point.
open <addr> <port>
opens a TCP connection to the given IP port and
address. If noarguments are provided, the device will
attempt to connect to the stored remote host IP
address and remote port number. <addr> can also be a
DNS hostname and will be resolved if entered.
Ping <g / h | I | addr > <num>
ping remote host. Default sends 1 packet. Optional
<num> sends <num> pings at 10 per second.
Ping 10.20.20.12 10 – pings IP address 10 times
ping g pings the gateway, the gateway IP address is
loaded if DHCP is turned on, otherwise it should be set
with the set ip gateway <addr> command
ping h pings the stored host IP address, the host IP
address can be set with the set ip host <addr>
command
ping I pings a known Internet server at
www.neelum.com by first resolving the URL (proves