Hunter 386 Owner's Manual page 37

STORAGE/WINTERIZATION
engine oil into the intake pipe or
manifold while engine is turning.
DO NOT USE the starter to turn
engine or serious engine damage
may result.
6. Tape the openings of the intake
and exhaust manifolds with duct tape
to help prevent corrosion of the
upper cylinder during lay-up.
7. Scrape all rust or corrosion from
exposed metal parts and surfaces.
Scrub all metal
detergent and rinse thoroughly. Paint
any bare metal.
8. Place a dust cover over engine.
Do not leave engine exposed to rain
and sea breeze.
9. Disconnect the battery cables;
remove the battery from the boat.
Clean the terminal ends and battery
with a solution of baking soda and
water and rinse thoroughly with
clean water. Apply a light coat of
grease on the terminal end of the
battery and cables. Store the battery
in a cool dry place. Use a trickle
charger to keep battery charged. Do
not charge battery near any open
flame or in a confined area.
CAUTION: Wear safety goggles
and rubber gloves to protect your
eyes and skin.
DEPARTURE FROM THE BOAT
The check list for leaving a boat
unattended is very
because items overlooked often will
not be remembered until you are far
from the boat and corrective actions
are impractical or impossible.
surfaces with
important
Primary choices for this list are items
relating to the safety and security of
the unattended craft: turning off fuel
valves, properly setting electrical
switches, pumping out bilge and
leaving the switch on automatic (or
arrange for periodic pumping out). It
is recommended that the power
be turned off when leaving the
boat. Other departure
items are securing ports, windows,
hatches and doors.
ROUTINE MAINTENANCE
Routine maintenance
should include items based on how
much the boat is used (usually in
terms of engine hours) and on
calendar dates (weekly, monthly or
seasonal checks). Typical of the
former are oil level checks and
changes, and oil and fuel filter
changes.
On a calendar basis the lists should
note such matters as electrolyte
levels in storage batteries, pressure
gauges on dry
extinguishers, and all navigation
lights. Check the
automatic bilge alarms or pump
switches by running water into the
boat. Periodically close and open
sea cocks several times to ensure
their free and easy operation in case
they are needed in an emergency.
Equipment and supplies carried on
board for emergencies should be
inspected for any
deterioration.
checklist
checklists
chemical fire
operation of
signs of
PAGE 33