Fabric Care - Hunter 386 Owner's Manual

These patterns, like all upholstery fabrics
and vinyl, require a regularly scheduled
cleaning program. A thorough cleaning
should be administered on a daily, weekly or
monthly basis depending on use and
exposure to dirt and/or staining agents. It is
important to begin treatment of a stain as
soon as possible after a spill. It is important
that efforts begin immediately after a spill to
remove any potential staining agent. It is
advisable to clean these products as soon
as the first signs of dinginess occur,
otherwise, delaying clean up will require a
much greater effort to restore the product to
its original appearance.
Regular cleaning requires the use of a mild
cleaner such as Murphy's Oil soap and
water. In situations where the vinyl has not
been washed regularly and there is a build
up of dirt, stronger vinyl cleaners such as
Simonize's Tuff Stuff or Turtle Wax's
vinyl/fabric cleaner are recommended. We
do not recommended the use of any other
cleaners. The use of cleaners other than
Do not use acetone or other harsh cleaners on the vinyl
soft headliner. Use soapy water or other mild detergent
to avoid damage to the vinyl.
Vinyl: Clean with mild soap and water. Wipe
with vinyl or upholstery cleaner monthly, and
especially before and after storage.
Leather: Mild soap water. Blot dry. Do not
scrub as this will stretch and scratch. Wipe
with leather cleaner/oil to preserve and help
prevent cracks before and after storage.
Fabric: Blot dry. Do not machine wash. Use
only mild soap and water. Wipe with a clean
white cloth. If stain persists, dry clean. Be
sure to treat cleaned surfaces with scotch
guard. Stretched or loose covers may be
REPAIR OF POLTURETHANE (MINWAX) FLOORS
Surface Scratches: Sand floor with 220 grit sandpaper. Remove all dust with clean cotton cloth
or blow off with air. Apply one coat of minwax evenly over sanded floor. Let dry completely, at
least 24 hours
Deep Scratches: Remove all blemishes by sanding floor with 220, until all minwax is removed
and you have a raw floor. Remove all dust with clean cloth or blow off with air. Apply one coat
evenly over floor. Let dry four to six hours. Repeat steps one and four. Apply third coat of minwax
only if needed by repeating steps one and four.) After final coat, let floor dry completely at least
one day.
VINYL CARE
those
irreparable damage to the product.
In order for the above listed cleaning
solutions to work effectively on stubborn
stains, please allow time for the cleaning
solution to soak in thoroughly. Be sure to
remove the cleaning solution before it has
time to dry. Regardless of the type of
cleaner used, it is necessary to finish up with
a thorough rinse using fresh water on a
clean sponge or rag. A soft bristled nylon or
natural fiber brush can be used to remove
built-up dirt and staining agents.
Finally, please remember that all our fabric
grain vinyls require a greater cleaning effort
to maintain than comparable smooth grain
vinyls. These products will provide an
attractive
conventional fabrics and vinyls if properly
maintained. One must realize that the proper
installation and use of our fabric grain vinyls
require
establishment and maintenance of a well
thought out cleaning program.

FABRIC CARE

steam cleaned. If foam is removed, it will
restuff more easily if wrapped with thin
plastic.
Storage: Cover with airflow fabric to reduce
dust build up. Do not use plastic, as this will
cause cushions to sweat and mildew.
Cushions: If wet, prop cushions vertically to
promote airflow around each cushion.
Cushions can be cleaned by most dry
cleaners. Dry clean only.
recommended may result
and durable alternative
additional attention
PAGE 29
in
to
to the