Configure The Mst Region For A Switch - Huawei Quidway S3000 Series Operation Manual

Operation Manual - STP
Quidway S3000 Series Ethernet Switches
display active-region-configuration command shows the parameters configured
before MSTP is enabled. For those configured after MSTP is enabled, you can use the
related display commands to display. For detailed information, refer to the "Display and
Debug MSTP" section. .
You do not have to perform all the mentioned tasks to configure MSTP. Many of them
are designed to adjust the MSTP parameters provided with default values. You can
configure these parameters per the actual conditions or simply take the defaults. For
detail information, refer to the task description or the Command Manual.
Note:
When GVRP and MSTP startup on the switch simultaneously, GVRP packets will propagate along CIST
which is a spanning tree instance. In this case, if you want to issue a certain VLAN through GVRP on the
network, you should make sure that the VLAN is mapped to CIST when configuring the VLAN mapping
table of MSTP.
CIST is spanning tree instance 0.

2.2.1 Configure the MST Region for a Switch

Which MST region a switch belongs to is determined with the configurations of the
region name, VLAN mapping table, and MSTP revision level. You can perform the
following configurations to put a switch into an MST region.
Follow the procedure listed in the table below and perform these configurations from
system view.
I. Enter MST region view
Perform the following configuration in system view.
Table2-1 Enter MST region view
Enter MST region view (from system view)
Restore the default settings of MST region
II. Configure the MST Region
Perform the following configuration in MST region view.
Operation
2-11
Chapter 1 RSTP Configuration
Command
stp region-configuration
undo stp region-configuration