Set Specified Port To Be An Edgeport; Set Path Cost Of The Specified Port - Huawei Quidway S3000 Series Operation Manual

Operation Manual - STP
Quidway S3000 Series Ethernet Switches
By default, the maximum transmission speed is 3 (a counter value without unit) on all
the Ethernet ports of the bridge.

1.2.11 Set Specified Port to be an EdgePort

EdgePort is not connected to any switch directly or indirectly via the connected
network.
You can use the following command to set a specified port as an EdgePort.
Perform the following configurations in Ethernet port view.
Table1-11 Set specified port as the EdgePort
Set a specified port as an EdgePort or a non-EdgePort
Set the specified port as the non-EdgePort, as defaulted
In the process of recalculating the spanning tree, the EdgePort can transfer to the
forwarding state directly and reduce unnecessary transition time.
Ethernet port is not connected with any Ethernet port of other bridges, this port should
be set as an EdgePort. If a specified port connected to a port of any other bridge is
configured as an edge port, RSTP will automatically detect and reconfigure it as a
non-EdgePort.
After the network topology changed, if a configured non-EdgePort changes to an
EdgePort and is not connected to any other port, it is recommended to configure it as
an EdgePort manually because RSTP cannot configure a non-EdgePort as an
EdgePort automatically.
Configure the port directly connected to the terminal as an EdgePort, so that the port
can transfer immediately to the forwarding state.
By default, all the Ethernet ports are configured as non-EdgePort.

1.2.12 Set Path Cost of the Specified Port

The path cost of Ethernet port is related to the speed of a link connected to the port.
You can use the following command to set the Path Cost of a specified port.
Perform the following configurations in Ethernet port view.
Operation
1-14
Chapter 1 RSTP Configuration
Command
stp edged-port { enable | disable }
undo stp edged-port
If the current