Table of Contents
Advertisement
8. Fill the measuring device with the sample
evenly distributed to ensure reproducible
results.
9. Remove material till the next lower weight
range is reached. If only a little missing
(e.g. 0,10kg) to the next higher level, it
should be filled up to that stage. The actual
weight is shown on the scale.
10.
Smooth the material by hand.
11. Select the right calibration curve for
your material under test using the
buttons
material in the measuring chamber must
be the same as the calibration curve.
The display shows the water content.
12. If the measure value is blinking, the
valid measuring range is exceeded (limits
see list on page 5). In this case the
accuracy will be decreasing. If you are
measuring wood chips, select the next
higher weight class and refill wood chips
to reach the higher filling weight.
Version 2.5_en
or
. The weight of the
page 3
Advertisement
Table of Contents
