Table of Contents
Advertisement
Damage may occur to the rear connector panel or the circuit board if the
installation instructions are not properly followed.
• Rear connector panel MUST be installed before the front-mounted circuit board.
•
If a circuit board should occupy a chassis frame slot where a rear connector panel is to be
added or changed, the circuit card MUST be removed or slid out a minimum of two inches
from the front side of the chassis frame before installing the rear connector panel.
It is not necessary to remove power to the chassis frame prior to installing a processing module.
3.2.1 I
R
NSTALL
EAR
Install rear connector panel as follows:
1. If your processing module was shipped with the rear connector panel attached to the main circuit
board, separate the two units.
2. Figure 3-1 illustrates the connector panel installation process using a single-width panel fitted
with BNC connectors; however the procedure is identical for installing a rear panel equipped with
6-pin detachable connectors.
3. Orient the rear connector panel with the main board connector toward the lower edge of the
chassis.
4. Install the panel by pressing it upward under the top lip of the chassis frame, and move the panel
toward the chassis until it is flat against the chassis frame, refer to Figure 3-1.
5. Allow the bottom edge of the connector panel to drop down into its mating slot at the bottom of
the lower edge of the chassis.
6. Install retention screw through connector panel to chassis frame, but DO NOT fully tighten the
retention screw, leaving the rear panel freedom to move, until after the Main Circuit Board is
installed per Paragraph 3.2.2.
DO NOT fully tighten the retention screw until after the Main Circuit Board is
installed. Severe damage could occur to the main board connector if the rear
panel is tightly secured prior to installing the main board.
Proprietary Information of QuStream
C
P
ONNECTOR
ANEL
Publication 81-9059-0632-0, Rev. A
CAUTION
CAUTION
I
600 – AES600 F
NTEGRITY
June 2008
AMILY
3-2
Advertisement
Table of Contents
