Table of Contents
Advertisement
Do not force the card into position. If the card does not seat with gentle pressure, back it out,
realign with the card guides and reinsert the card.
6. When the card is properly seated, press the card ejector lever toward the board to lock the card in
position.
7. Once the main board is seated and locked, and all connectors have properly mated, secure the rear
connector panel to the chassis frame by tightening the retention screw.
8. Close the chassis frame front access door.
3.3
R
P
S
EAR
ANEL
IGNAL
Input and output connections to the module are made through 6-pin detachable connectors on the single-
width rear connector panel. Each connector provides 2 physical input or output connections for a total
of 2 Input and 14 Output connections on each rear panel. Rear connector panel layout is shown in
Figure 3-3. When making audio connections to the AAB6214 module, follow the pin-out data for rear
panel audio connections presented by Figure 3-4 and Table 3-1. Use good quality cable and ensure that
the mating plug is properly installed.
Proprietary Information of QuStream
NOTE
Figure 3-2 Installing Main Circuit Board
C
ONNECTIONS
I
600 – AES600 F
NTEGRITY
Publication 81-9059-0632-0, Rev. A
AMILY
June 2008
3-4
Advertisement
Table of Contents
