Table of Contents
Advertisement
4.1
O
PERATION
There are no operating controls located on the AAB600 modules. Certain operating parameters of the
DA module may be selected or modified through an external control device such as the Integrity 600
Series Remote Control Panel RCP-503, or the SOFT603 PC based software application, if the chassis
frame is equipped with at least one NET 603 Frame Controller module. While most installations do
contain the frame controller card, the AAB6214 module will function without a controller card present
in the frame; however, options from the configuration menus discussed in this chapter can not be chosen
or changed in the field. The module will be factory programmed prior to shipment. Refer to the RCP-
503 Technical Manual, QuStream Publication 81-9059-XXX-0 for control panel operation procedures.
The following paragraphs introduce the configuration options and adjustments available through each
configuration menu.
4.2
M
M
- S
AIN
ENU
Figure 4-1 shows screen 1 of the main menu display for the AAB6214 DA module. Entries on the menu
screen and functions available through each are discussed below.
LINKING
Gain of each analog input signal can be adjusted by selections on the main menu screen in one of two
ways - the audio channels may be adjusted independently (Linking Off) or the two signals may be
linked together (Linking On). When the signals are linked, gain for both channels is adjusted as a group
by a single control, and the balance between the two may be adjusted. Select the desired linking mode
Proprietary Information of Q
1
CREEN
Figure 4-1 Main Menu Screen 1
S
U
TREAM
Integrity 600 – AAB6214 Analog Audio DA
Publication 81-9059-0631-0, Rev. A
Chapter 4 Operation
July 2008
4-1
Advertisement
Table of Contents
