Tuner - Philips FW930P2/2 User Manual

MINI HIFI SYSTEM
PROGRAM SHUFFLE
REPEAT TIMER REC
NEWS T.A. AM MW FM LW
60Hz
STANDBY
ON
CLOCK/
TIMER CD1 • 2 • 3
CD
PROG
SEARCH • TUNING
INCREDIBLE
SURROUND
SOUND CONTROL
Note:
– For 'EASY SET' feature, please refer to
page 11.
Tuning to radio stations
1 Press TUNER (BAND) to select TUNER
mode.
™ "TUNER" will be displayed.
A few seconds later, the current radio
frequency will be displayed.
2 Press TUNER (BAND) again to select
the desired waveband : FM, MW or LW.
3 Press TUNING à or á for more than
one second, then release.
™ The display will show "SEARCH"
until a radio station with sufficient
signal strength is found.
• Repeat this procedure until the desired
station is reached.
STEREO
BACK
FRONT HSD
8KHz
250Hz 500Hz 1KHz 2KHz 4KHz
BAND TAPE 1 • 2 CDR
VOLUME

TUNER

TAPE AUX
A. REV
A. REV
SIDE A•B PRESET
STOP•CLEAR PLAY PAUSE PREV NEXT
SOUND NAVIGATION
DYNAMIC BASS
BOOST
DIGITAL
• To tune to a weak radio station, briefly
press TUNING à or á repeatedly
until the display shows the desired
frequency and/or when the best
reception has been obtained.
Storing Preset Stations
You can store up to 40 radio stations in the
memory. When a preset radio station is
selected, the preset number appears next
RDS
to the frequency on the display.
NEWS/TA NEWS!
Automatic programming
1 Press TUNER (BAND).
2 Press PROGRAM for more than one
second.
MIC
LEVEL
™ The
flag starts flashing and
PROGRAM
MIC
"AUTO" will be displayed.
™ The system will search for every
available station in the FM waveband
first, then search by the MW and LW
wavebands.
™ All available radio stations will be
stored automatically. The frequency
and preset number will be displayed
briefly.
™ The system will stop searching when
all the available radio stations are
stored or when the memory for 40
preset radio stations is used.
™ The system will remain tuned to the
last stored preset radio station.
Notes:
– You can cancel the automatic
programming by pressing PROGRAM or
STOP•CLEAR Ç (on the system only).
TUNER
– If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10 before
starting automatic programming: only
the preset numbers 10 to 40 will be
programmed.
Manual programming
1 Press TUNER (BAND).
2 Press TUNER (BAND) again to select
the desired waveband : FM, MW or LW.
3 Press PROGRAM for less than one
second.
™ The flag starts flashing.
PROGRAM
™ The next available preset number will
be displayed for selection.
4 Press TUNING à or á to tune to the
desired frequency.
• If you wish to store the radio station to
another preset number, press PRESET
4 or 3 to select the desired preset
number.
5 Press PROGRAM again.
™ The
flag disappears and the
PROGRAM
radio station will be stored.
• Repeat the steps 3 to 5 to store other
preset radio stations.
Notes:
– When 40 radio stations are stored and
you attempt to store another radio
station, the display will show " FULL ".
If you want to change an existing preset
number, repeat steps 3 – 5.
23