Preparation Of Conduit Wiring; Connection Of Conduit Wiring To Unit - Robertshaw 365A Instruction Manual

MODEL 365A & E365A
VIBRASWITCH® MALFUNCTION DETECTOR
To avoid unnecessary difficulty in wiring the unit, the following recommended procedure should be used:
•
Wires should be trimmed to project beyond the cover mating surface of the enclosure base by
approximately 1 ½". Do not pull wires tight, as you may be unable to remove cover sub-
assembly.
•
Strip the wires ¼" and install solderless terminals as necessary.
•
Rest the cover sub-assembly on the mating surface and connect the wires to the appropriate
terminals.
•
Flatten wires entering housing against wall on the conduit hub side and rotate cover sub-assembly
into place, pushing extra wire into corners near hub.
•
Replace the cover bolts and torque them to 75-100 inch pounds.
Figure 3.5 – Connection of Conduit Wiring to unit
Figure 3.4 - Preparation of Conduit Wiring
PAGE 10
INSTRUCTION MANUAL
909GF294